ATCC Medium: 37 Chromatium Medium
Solution 1
CaCl2………………………………………0.8 g
DI Water…………………………………...1000 ml
Adjust the pH to 6.6-6.8. The medium should be dispensed into sterile 16x125 screw cap tubes.
Fill the tubes to about 1/8 of an inch from the top. Autoclave at 121oC
Note: Media may be dispensed aseptically to avoid boil over. If not, I would recommend using rubber screw caps.
Solution 2
Heavy Metal Solution (see below)…………….50.0 ml
Vitamin B12 Solution (see below)……………...3.0 ml
Vitamin Solution (see below)………………….15.0 ml
KH2PO4…………………………………………..1.0 g
KCl………………………………………………..1.0 g
NH4Cl……………………….…………………….0.8 g
MgCl2 x 6H2O……………………………………0.8 g
Sodium Ascorbate……………………………....2.4 g
DI Water……………………………….………….32.0 ml
Solution 3
NaHCO3…………………………………….…….4.5 g
DI Water……………………………….………….900.0 ml
Combine Solutions 2 and 3. Adjust the pH to 6.6-6.8. The medium should be dispensed into sterile 16x125 screw cap tubes. Fill the tubes to about 1/8 of an inch from the top. Autoclave @ 121C.
Note: Media may be dispensed aseptically to avoid boil over. If not, I would recommend using rubber screw caps.
Solution 4
This may be added by the bacteriologist.
Na2S x 9H2O……………………………..………….3.0 g
DI Water………………………………………..……200.0 ml
Gas under N2. Dispense into Hungate tubes or bottles. Generally 4-5 test tubes (8-10ml each is sufficient). Autoclave @ 121C Heavy Metal
Solution Ethlyene Diamine Tetraacetate……………………….…….1.5 g
Modified Hogland trace elements solution (see below)…...6.0 ml
FeSO4 x 7H2O..………………………………………………...0.2 g
ZnSO4x 7H2O……………………………………………..……0.1 g
MnCl2 x 4H2O…………………………………………………...0.02 g
DI Water……………………………………………….………..1000 ml
*Dissolve EDTA first Vitamin B12
Solution Vitamin B12……………………………………………………2.0 mg
DI Water………………………………………………………100.0 ml
Vitamin Solution (May substitute ATCC Vitamin Supplement) Biotin…………………………………….……………………..0.2 mg
Nicotinic Acid..…………………………………………………2.0mg
Thiamin…………………………………………………….…..1.0 mg
p-Aminobenzoic acid………………………………………….0.1mg
Pantothenic acid……………………………………………….0.5 mg
Pyrodoxamine HCl……………………………………………5.0 mg
DI Water……………………………………………………..…100.0 ml
Modified Hogland Trace Element Solution (May substitute ATCC Trace Minerals)
AlCl3………………………………………………………….1.0 g
KI…………………………………………………………….1.0 g
KBr…………………………………………………………...0.5 g
LiCl…………………………………………………………..0.5 g
MnCl2 x 4H2O……………………………………………….7.0 g
H3BO3……………………………………………….………11.0 g
ZnCl2…………………………………………………….…..1.0 g
CuCl2…………………………………………………….…..1.0 g
NiCl2…………………………………………………………1.0 g
CoCl2………………………………………………………...1.0 g
SnCl2 x 2H2O………………………………………………..0.5 g
BaCl2………………………………………………..………..0.5 g
Na2MoO4…………………………………………………..…0.5 g
NaVO3 x H2O…………………………………………..…….0.1 g
Se-Salt (Na selenite)………………………………………..0.5 g
DI Water………………………………………………….….3600 ml
Each salt is dissolved in distilled water before mixing; pH of each solution is adjusted to below 7.0. The final pH is adjusted to 3-4.
Before use, the solution is thoroughly mixed. The total final volume is 3.6 liters. The pH of the final solution is adjusted to pH 3-4.
The flaky yellow precipitate which is formed after mixing transforms after a few days into a very fine white precipitate. Before use the 37 solution is mixed thoroughly.